Common problem areas we reproduce

•Grille and exterior trim clips
•Interior knobs, escutcheons and switch surrounds
•Dash vent components and levers
•Door and window-winder small plastics
•Grommets and seals through the body

How it works for your Golf Mk1

01
Reverse-engineer
We rebuild the geometry from your original sample - broken is fine.
02
Design & improve
Weak features are corrected in CAD before manufacture.
03
Manufacture
Produced in the right process and material for the location on the car.

No need to ship the part - a quote starts with photos.

We work on VW Golf Mk1 & Caddy (1974-1983) components to order - send photos of any part.

Request a quote

Frequently asked questions

Community 3D prints exist for my Mk1 part - why use you instead?

Hobby prints often fit approximately and age badly. We rebuild the geometry from a real sample, hold the dimensions that matter and produce in industrial materials - the difference shows at fitting time and two summers later.

Can you work from a broken or incomplete part?

Yes - fractures, missing tabs and warped areas are normal. We reconstruct geometry from the remaining features, the mating part and symmetry.

Can you produce a single piece, or only series?

It depends on the part, and we are upfront about it. Many components are viable as a single piece and we quote them that way. Others carry engineering, tooling or machine set-up costs that only make sense across a minimum quantity - where that applies we say so at quote stage, with the numbers, so you can decide before committing.

How do I start?

Send photos, rough dimensions and the vehicle details through the contact form; we usually respond within 24-48 hours.

Your project stays yours.

Every part we reverse-engineer and produce is confidential and exclusive to the client. We do not resell, share or reproduce a client's parts for anyone else unless the client explicitly authorises it. NDAs available on request.

Have a Golf Mk1 part that's NLA?