Pedal & lever components - reproduction & small batches
Pedal bushes, lever stops and pads are wear parts that were meant to be replaced - until the replacements stopped existing. Sloppy pedals and rattling levers are the result, in cars whose mechanical feel is the whole point. We reproduce these components in tougher modern polymers matched to the duty: low-friction where things pivot, grippy where feet land, dimensioned from your sample so the slop disappears.
How we make them
Measured from the worn part and its shaft or pivot, produced in wear-suited engineering polymers, dimensioned to restore original clearances rather than copy worn ones.
Typical work: pedal pivot bushes, gear and handbrake lever components, stops and pads for classic European cars.
We reproduce pedal & lever components to order - send photos of any part.
Request a quoteFrequently asked questions
Should you copy my worn bush exactly?
No - and we do not. We measure the shaft and housing to restore the designed clearance, so the pedal feels as it did when the car was new.
Which process will you use?
Whichever suits the part: MJF nylon for tough functional plastics, high-detail resin for fine features, CNC for metal or high-load parts, vacuum casting for small series.
One part or a batch - how does pricing work?
The engineering is a one-time cost; per-unit price drops with quantity. We quote both so you can decide.
Your project stays yours.
Every part we reverse-engineer and produce is confidential and exclusive to the client. We do not resell, share or reproduce a client's parts for anyone else unless the client explicitly authorises it. NDAs available on request.
Have a pedal part to remake?
Request a quoteRelated
Part numbers, vehicle names and model designations are manufacturer references used only to identify components. Replique Labs is an independent manufacturer and is not affiliated with, sponsored by or endorsed by any vehicle manufacturer.