
- Replique reference
- RL-W126-PINION
- Formatting variants
- -
- Brand
- Mercedes-Benz
- Type
- Speedometer pinion gear (12 teeth)
- System category
- Gears & Drive Components
- Model references
- W126 (designed on a 560 SEC)
Inside the speedometer of the Mercedes W126 there is a small plastic drive pinion with 12 teeth. This page is for a reproduction of that pinion, based on an open design made for a 560 SEC. A gear has to match the original closely to mesh properly, so we check your old pinion before we quote and choose a wear-resistant plastic for it. Send it to us, or clear photos with the teeth counted.
Based on the open design “Mercedes W126 560SEC Digital speedometer pinion gear (12 tooth)” by mikesc220, licensed under CC BY-SA.
How we reproduce it
- 01
Reverse-engineer
We rebuild geometry from your original - broken samples are fine.
- 02
Design & improve
Weak features get thicker walls, ribs and fillets in CAD.
- 03
Manufacture
Produced in the right process and material for how the part is used.
What to send for a quote
- •Multi-angle photos, including both mating faces
- •Rough dimensions in mm (calipers or ruler)
- •The part number if visible
- •Where it fits on the car
- •Quantity required
- •Deadline, if any
- •Tell us the quantity you need - we will confirm whether the part is viable as a single piece or requires a minimum batch.
Frequently asked questions
Will it fit my W126?
The designer modelled it on a 560 SEC. We check your original pinion before quoting, to make sure it matches.
Which material do you use?
A wear-resistant engineering plastic suited to gears, such as POM or nylon; we confirm it in the quote.
What if my part number is superseded?
Send the number you have; we trace the family and confirm the correct geometry from your photos.
Can you work from a broken or incomplete part?
Yes - fractures, missing tabs and warped areas are normal. We reconstruct geometry from the remaining features, the mating part and symmetry.
There's no CAD or drawing for this part. Is that a problem?
No. Most of what we make has no surviving documentation; we rebuild the model from your sample and photos.
How accurate is the reproduction?
We hold the tolerances that matter for fit and function - mating faces, clip engagement, hole positions - and verify dimensions before shipping.
Which process will you use?
Whichever suits the part: MJF nylon for tough functional plastics, high-detail resin for fine features, CNC for metal or high-load parts, vacuum casting for small series.
Can you produce a single piece, or only series?
It depends on the part, and we are upfront about it. Many components are viable as a single piece and we quote them that way. Others carry engineering, tooling or machine set-up costs that only make sense across a minimum quantity - where that applies we say so at quote stage, with the numbers, so you can decide before committing.
Your project stays yours.
Every part we reverse-engineer and produce is confidential and exclusive to the client. We do not resell, share or reproduce a client's parts for anyone else unless the client explicitly authorises it. NDAs available on request.
Related
Part numbers, vehicle names and model designations are manufacturer references used only to identify components. Replique Labs is an independent manufacturer and is not affiliated with, sponsored by or endorsed by any vehicle manufacturer.
Your project stays yours. Every part we reverse-engineer and produce is confidential and exclusive to the client. We do not resell, share or reproduce a client's parts for anyone else unless the client explicitly authorises it. NDAs available on request. Part numbers, vehicle names and model designations are manufacturer references used only to identify components. Replique Labs is an independent manufacturer and is not affiliated with, sponsored by or endorsed by any vehicle manufacturer.